RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: AD band pcb [打印本頁]

作者: 2slow 時間: 2007-3-15 10:55
標題: AD band pcb
1) Where can I buy the AD band PCB only? how much?
2) Does it comes with power switch and VR?
3) Can I install it to AWD?

唔該各位師兄...

作者: billy86che 時間: 2007-3-15 11:01

原帖由 2slow 於 2007-3-15 10:55 發表
1) Where can I buy the AD band PCB only? how much?
2) Does it comes with power switch and VR?
3) Can I install it to AWD?

唔該各位師兄...

1. KWS at about $6XX. (has become more expensive)
2. Yes.
3. Yes, but with some modification.

作者: 2slow 時間: 2007-3-15 11:06

原帖由 billy86che 於 2007-3-15 11:01 發表

1. KWS at about $6XX. (has become more expensive)
2. Yes.
3. Yes, but with some modification.

1. only PCB without the module? what about PCB with AD module?

3. what modifications is needed? can you describe it or show some photo?

Thanks...

作者: billy86che 時間: 2007-3-15 11:13

原帖由 2slow 於 2007-3-15 11:06 發表

1. only PCB without the module? what about PCB with AD module?

3. what modifications is needed? can you describe it or show some photo?

Thanks...

1. Without module still costs us $6XX.

3. Remove or move the white plug installed on the pcb(used to connect to computer).

作者: 2slow 時間: 2007-3-15 11:19

原帖由 billy86che 於 2007-3-15 11:13 發表

1. Without module still costs us $6XX.

3. Remove or move the white plug installed on the pcb(used to connect to computer).

1. what about PCB with module then, which shop in KWS have it?

3. White plug for connecting computer? so that means I can't tune it anymore?

Many thanks billy86che

作者: billy86che 時間: 2007-3-15 11:23

原帖由 2slow 於 2007-3-15 11:19 發表

1. what about PCB with module then, which shop in KWS have it?

3. White plug for connecting computer? so that means I can't tune it anymore?

Many thanks billy86che

1. In the old days, also $6XX. (It is nonsense.) Haven't seen it recently.

3. You can resolder it on the back of the PCB or you can wire it out and fit in at the rectangular hole on the chassis. (Kyosho has prepared something.)

[ 本帖最後由 billy86che 於 2007-3-15 11:30 編輯 ]

作者: 2slow 時間: 2007-3-15 11:29

原帖由 billy86che 於 2007-3-15 11:23 發表

1. In the old days, also $6XX. (It is nonsense.) Haven't seen it recently.

3. You an re solder it on the back of the PCB or you can wire it out and fit in at the rectangular hole on the cha ...

1. I see, will go check it out later.

3. wish someone can show me some photo..

Thanks anyway

作者: tonytjia@zone 時間: 2007-3-15 11:52
標題: 回復 #1 2slow 的帖子
萬里有AD PCB賣價大約$5xx
極速 AD PCB + Module + AD Band Crystal 價$700
我會建議你買 ADPCB + Module + AD Band Crystal 因為祇係$700

ADPCB 有VR, Servo motor 及開關

如果你要裝向AWD度要改長開關線及電池到PCB條線

Servo motor 正負線要交換

同埋chassis要cut小小先裝到

作者: 2slow 時間: 2007-3-15 11:56

原帖由 tonytjia@zone 於 2007-3-15 11:52 發表
萬里有AD PCB賣價大約$5xx
極速 AD PCB + Module + AD Band Crystal 價$700
我會建議你買 ADPCB + Module + AD Band Crystal 因為祇係$700

ADPCB 有VR, Servo motor 及開關

如果你要裝向AWD度要改長開關 ...

哦~ 自已整容易嗎? KWS有無shop可以幫我裝呢?

Thanks

作者: billy86che 時間: 2007-3-15 13:14

原帖由 2slow 於 2007-3-15 11:56 發表

KWS有無shop可以幫我裝呢?

Thanks

Probable. Go and ask.

作者: tonytjia@zone 時間: 2007-3-15 15:00
標題: 回復 #9 2slow 的帖子
我都係自己整
第一次整可能會耐D大約一小時
我等二架整左半個鐘

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://rc-evo.com/xbbs/)