買左AE B44.3的要注意!!!

好高興最快買到而高興!但係一裝架車先發現出事!
1)叉速密豐用介子#9888外直徑大左DD,依MANUAL裝,加油合起了,才放BEARING#6903,包你又要分番開多一次!搞到成手油!!!
2)裝底板時,發現有D螺絲凸起,有Ｄ又正常,鬆開一粒放去空洞位一試,原來SCREW HEAD ANGLE不對,重搖得侑!!之後磨開半粒SCREW,
再用台單反近影,發現真係!,立即帶埋架車出車鋪問問如何,他說會話比代理聽.
因今曰會入倉玩,所以要汁汁行理,無新車玩,只好玩住LOSI XXX4,發現有粒螺唔見左,就去巢下,點知一巢到,因同是(4-40)想一想試下放
入去台44.3,點知合渦?????原來拒比左兩種不同螺絲頭比人,所以出問題!但兩款也是(4-40)牙?????

終於明白AE出了乜錯,---亞蘇士---我幫你伐到原因快D送十盒新車比我,否則我X你乜乜

老牌大廠都有呢Ｄ問題

依家佢Ｄ鏍絲行晒公制未?

三條叉行了2.5MM外則未有發現

問題出在R&D QC和採購之上

                               
登錄/註冊後可看大圖

淨係呢張圖己值得亞蘇士多謝你......C兄堅有心有力.....

AE 都出事!?

在香港想買到合用的美製螺絲只得一個{吊字}

好在我有好多中古LOSI ,由JRX2到XXX4也有所以不怕但其它人

LAZER-ZXR_GP 發表於 2014-10-9 11:26
在香港想買到合用的美製螺絲只得一個{吊字}

44.3仲用緊美制鏍絲??

用乜制唔係問題,而泥次係管理問題

What the  {banned}. Then it seems Team c is not too worse.

Don't even know it is out already!

My .2 is still not built ar ..

ya, metric countersunk screw head is 45degree, 4-40 i think is 43.5 or something......  slightly different.  Bad QC  

亞蘇士近年的質量的確差了！

AE quality seems to have gone down a bit. But looking forward to seeing how this compares on the track vs centre slipper cars. Performance on track most important

盒內加送一包#9940

咁正？check 吓我盒會唔會多塊底板先！

底板行弟ニ,SHOCK行先!因出路多好多