Tamiya RM-01 full option

very nice and fit................

yes full option with Tamiya

Finish ....................ready to run

4000KV

前轆可改用5x8F bearing 就可用普通十二仔呔軨

昨晚第一次玩，感覺良好，只是roll damper油希左d，見意頭4mm螺絲換長d。

回復 Zenki 的帖子

IP 6200 3.7V, Dualsky 8.5D stock motor (around 4000KV), 96/35, over 8 minute

回復 albertau2011 的帖子

for 1 cell no problem, coz is 8.5T motor

Trinity 30WT, now change to 45WT

Diff ball and diff ball plate are original, Supr Gear is Kawada

放到2CELL short pack

用到, rear is std, front change 8x5F bearing can use 其它廠呔呤

Or........

54366 RM-01 Front Upright Shaft (for 1/8x5/16 Inch Bearing)
The upgraded upright shafts are a replacement of the standard shafts used in the stock plastic uprights. These allow the use of aftermarket 1/12th scale wheels that use the 1/8 x 5/16th inch bearings. The standard wheel axle uses metric size bearings for use on Tamiya wheels. The use of inch size bearings will open up the racers options.