NT-18

試車報告

小弟已於2月25日試過車.

1. 用Hudy 出的專用start box, 真係好方便, 只需用一排電, 體積又細, 比起我個1:10 用ThunderTiger Start Box 真係輕巧好多.
2. 這部車加上其原裝Engine , 調教唔難, 好易掌握, 真係好鬼快, 可以話同我部Mega 15 級Engine 係一樣快, 不過應該快唔過18級engine.
3. 大家記住...最好最好, 唔好用海綿呔...否則...好似將$60 包住o的呔黎走咁...好快蝕晒o的呔, 我其後走左幾缸油, 轉用以前玩 1:18仔的膠呔, 好好多.
4. 佢行直路冇咩問題, 但轉向要用o的大力少少的servo 先得...
5. 佢原裝跟黎的接收用Battery Pack係四粒AAA 串聯電黎...唔係好夠力咁...我DIY 5粒AAA 電, 情況大大改善, 精神晒.
6. 大家要小心, set full-throttle 時, 有機會會拉到個brake rod...咁...要小心set 好個位, 我打算整鬆個engine 再將佢個位set 過.
7. 原本諗住係屋企玩下佢...點知...佢個Engine 都好鬼响...我最後打消念頭!
8. 大家要記得落Air-filter oil 落個air-filter 度...因為佢吸風吸得好勁...否則...engine 內部會變得好dirty... 我玩左兩個鍾...佢個air-filter 黑晒...好彩我有用air-filter oil!
9. NT-18 同佢個堂兄-M-18 有個好證, 就係前dumper 好易, 大家要小心, 我玩左一陣, 已經花花地了...買返個新的parts 要$50 around.
10. 用返原裝個12度caster 已經係夠用了, 如用6度caster 會便到頭shock 唔係咁work..

[ 本帖最後由 purplestar 於 2006-3-9 11:23 編輯 ]

thx for your share.

原帖由 purplestar 於 2006-2-27 01:59 發表
小弟已於2月25日試過車.

1. 用Hudy 出的專用start box, 真係好方便, 只需用一排電, 體積又細, 比起我個1:10 用ThunderTiger Start Box 真係輕巧好多.
2. 這部車加上其原裝Engine , 調教唔難, 好易掌握, 真係好 ...

Good to see your test report, have fun with the little rocket ...  

原帖由 purplestar 於 2006-2-25 02:19 發表
Brake System

Brother purplestar, I found it was so tight after I installed the brake system.  I did sand the brake pad a little bit  but still no helpl!  Do you have similar problem or any suggestion?  Thx!

[ 本帖最後由 skye 於 2006-2-27 10:43 編輯 ]

原帖由 skye 於 2006-2-27 10:38 AM 發表


Brother purplestar, I found it was so tight after I installed the brake system.  I did sand the brake pad a little bit  but still no helpl!  Do you have similar problem or any suggestion?  Thx!

yes, I have the same problem, but sovled...
I suggest you should adjust the 'linkage rod", it does help a lot.

Do you mean the one link with the servo horn?  I haven't put it on yet.

原帖由 brother 於 2006-2-27 07:30 PM 發表
請問NT18中軸與M18中軸是否一樣.Thks.

一樣架!!

not same worr, NT18 drive shaft have longer flat surface for brake disc worr....

How to set the down stop on NT18

原帖由 purplestar 於 2006-2-27 03:50 PM 發表


yes, I have the same problem, but sovled...
I suggest you should adjust the 'linkage rod", it does help a lot.

i hope the following photos can help to solve your problems la...

原帖由 purplestar 於 2006-2-28 07:43 AM 發表


一樣架!!

yes, brother, I checked it yesterday, it's longer!

原帖由 AngusLau 於 2006-3-1 01:51 AM 發表
How to set the down stop on NT18

前後都係各用兩粒"機米" set 架咋.
easy.

the gear is like EP TT-01

小弟想請問呢架車仔日後有無補品出架？同埋副偈可唔可以升級用其他牌子架？我真係好想買呢部車仔，所以先做下調查一下，謝謝各位。

我都好有興趣,呢部車咩場玩到?

DIY 殼桂補強
當年玩M18 時, 前殼桂及前bumper 成日撞爛架.
其他就冇乜爛, 所以要DIY 殼桂補強.

[ 本帖最後由 purplestar 於 2006-3-9 11:15 編輯 ]

原帖由 sunnyshao007 於 2006-3-4 04:44 PM 發表
the gear is like EP TT-01

yes ar,
好多車, 某o的陪份, 都係互相"參考"黎做架啦.

原帖由 kennily 於 2006-3-7 04:38 PM 發表
我都好有興趣,呢部車咩場玩到?

其實有人係18仔場玩, 亦好多人開左依部車.
西灣應該好多人玩這架野, 就好似當年M18 仔一樣...

原帖由 wasino3318 於 2006-3-5 01:00 AM 發表
小弟想請問呢架車仔日後有無補品出架？同埋副偈可唔可以升級用其他牌子架？我真係好想買呢部車仔，所以先做下調查一下，謝謝各位。

brother,
其實現在已經有齊俾M18 的補品, 而NT18 好多同engine 冇關的補品都可以用返M18 仔的. e.g. toe in, caster, option shocks/springs, roll-bar, etc.

而現時engine 只得一款...遲o的就唔知啦...

Xray 出品的東西, 信心保證.

希望幫到你.