RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: ko 2.4 g急問 [打印本頁]

作者: sam    時間: 2008-11-30 00:10
標題: ko 2.4 g急問
請問ko 2.4g對應怎樣做,(無左說明書)
THX
作者: topham    時間: 2008-11-30 11:27
The binding procedures should as,

1. Hold the button on the back of the module and turn on the Tx.
2. Continue to hold the button until the LED on the module goes out and release the button. The LED will come back on but will be dimmed.
3. Hold the button on the rx and turn on the power to the rx.
4. Once the LED comes on, you can release the button. The LED will go dim and come back on very quickly.
5. Turn the rx and then the Tx off and then turn both back on again.

Hope this can help..
作者: sam    時間: 2008-11-30 11:31
thx
作者: topham    時間: 2008-11-30 11:40
Almost forgot,.. you also can set the fail safe for throttle once complete binding,  -  When the tx and rx are on, hold the trigger at the fail safe position and press the rx button for 3 sec. and release. (when the LED light goes out). You can verify once the tx turned off.




歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://rc-evo.com/xbbs/) Powered by Discuz! X3.2