標題: Open hole for car shell [打印本頁] 作者: st_kuen 時間: 2009-5-26 14:01 標題: Open hole for car shell C-hing,
May I ask how to make a big hole (approx. 50mm dia.) in the front and rear glass of car shell for ventilation of Engine.
I see many C-hings can make it in perfect circle.
Any special equipment to do it?
Same equipment as the one to make hole for 殼柱?
Thanks!作者: superx 時間: 2009-5-26 14:11
there has a special pair of scissos are use to cut car shell, the tip of the sessios is a little bit bend , specially for you to cut the circle edge of the shell作者: 天娜 時間: 2009-5-26 14:15
你可以買把"圓規刀"作者: hk_sdu 時間: 2009-5-26 14:32
yes, some bookstore will have this 圓規刀作者: st_kuen 時間: 2009-5-26 14:47
I see! Thanks! All C-hings
Thanks! All C-hings