RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 好明顯我係亂咁o黎… [打印本頁]

作者: Scania 時間: 2010-7-1 10:34
標題: 好明顯我係亂咁o黎…
[attach]389930[/attach]

作者: jack_so 時間: 2010-7-1 11:00
要行就行到既,不過轉彎就

小心小心

作者: Scania 時間: 2010-7-1 11:06

要行就行到既,不過轉彎就小心小心
jack_so 發表於 2010-7-1 11:00 AM

登錄/註冊後可看大圖

原裝跟個把叉唔o岩size，等緊佢寄過件來…

作者: jack_so 時間: 2010-7-1 11:13
亂兄

ok勁鍋

作者: Scania 時間: 2010-7-1 11:37
我反而驚我隻老爺sevor咁擺法會高得濟頂殼，到時又要再執過

作者: abcde 時間: 2010-7-1 18:30
本帖最後由 abcde 於 2010-7-1 18:42 編輯

this servo install is for low profile servo...not for those 3003..you need cut ear and stand up the servo to install ar.... you must read the manual carefully ar...otherwise you can't turn...no car is just for run straight....circuit must need to turn around ga....sigh....

作者: Scania 時間: 2010-7-1 18:59

this servo install is for low profile servo...not for those 3003..you need cut ear and stand up the ...
abcde 發表於 2010-7-1 06:30 PM

登錄/註冊後可看大圖

我裝好左先發覺奶左野…

作者: abcde 時間: 2010-7-1 23:51
then install it again!!...if you just want to take photo but not run it..then...everything OK...but if you want to put it on ground...then install it again with what manual say....there are two servo mount in the kit.....do it or not..just what you choice...but as i also play f109 and 2wd player....hope you really play it no matter on what track or even on the playground.....

作者: 93461612 時間: 2010-7-11 09:52
回復 7# Scania

換左金屬前擺臂座啊・好易難架
http://hk.3racing.hk/products.php?products_key=2737

作者: Scania 時間: 2010-7-11 23:29
搞掂左，但隻老爺接收虧左…

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://rc-evo.com/xbbs/)