RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Dismantling the Engine Cylinder & Inner Head [打印本頁]

作者: st_kuen 時間: 2010-9-22 00:45
標題: Dismantling the Engine Cylinder & Inner Head
Just disassemble the engine for checking.
Find the Cylinder, shim & Inner Head are held firmly and cannot separate.
Any c-hing can share the experience for dismantling these.
Thanks in advance!

作者: beebone 時間: 2010-9-22 02:05
Yes, just right about overheating and operate for ling time.
Bearing will worn out, head oring sleeve all stuck together.

作者: stanley_wwy 時間: 2010-9-22 13:02

Just disassemble the engine for checking.
Find the Cylinder, shim & Inner Head are held firmly and ...
st_kuen 發表於 2010-9-22 00:45

登錄/註冊後可看大圖

use a heat gun or hair dryer to heat the crankcase first.

作者: chungtsai 時間: 2010-9-22 16:24
回復 1# st_kuen

黎TRC我話俾你知

作者: Fluke 時間: 2010-9-22 20:13

回復 st_kuen

黎TRC我話俾你知
chungtsai 發表於 2010-9-22 16:24

登錄/註冊後可看大圖

yes.

作者: st_kuen 時間: 2010-9-23 00:04
回復 4# chungtsai

TRC's c-hings are always helpful to freshman!
Especially those guys in the container which located at the corner!

作者: chungtsai 時間: 2010-9-23 18:47
I was pushed to the corner of the container.

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://rc-evo.com/xbbs/)