
原帖由 老人家 於 2006-8-7 01:52 發表
其實以上公式只作理想的参考 , 因一般充電時輸出的電壓一定要比原電壓高才可有效充地去充電 , 所以如你充一節1.2v3600mah充時 , 可能用上1.8v3600ma(3.6A) , 那便不是1小時充滿了 , 又因充電的初期電流電壓 ...

原帖由 edmundsfc 於 2006-8-10 06:14 發表
Help....
After 1hr 40min charge at 2.8A, my 3000mAh battery got very hot. Charger still didn't stop, and the capacity read 4200 on the charger LCD.
I was so concern, so I unplug it.
...
原帖由 Motorman 於 2006-8-9 14:31 發表
if your charger doesn't got (- delta V) adjustment, you have to stop the charger manually when you see the reading around 3100 and 3200 mAh...... otherwise, your battery will be overcharged. If ...
Then, what's the point to buy a "peak charger"原帖由 edmundsfc 於 2006-8-10 06:42 發表
Need to unplug manually??Then, what's the point to buy a "peak charger"
But 老人家 also mentioned in other post, the LCD could give wrong info.
What should I do 老人家?
原帖由 Motorman 於 2006-8-11 00:52 發表
Nowadays, almost all RC battery charger using "delta V" peak detection. The different between those charger is some could adjust the "delta V" value since different brands o ...
原帖由 老人家 於 2006-8-11 08:35 發表
多謝代答 , 補充一下充電流特性(鋰電除外) , 充至七至八成後正常下温度是會不斷上升 , 可充至3000以外也是正常因早前提個這些錶是哈哈錶只作参考 , 錶所出的數是用充入電×時間 , 無把線和接點 , 充 ...

原帖由 edmundsfc 於 2006-8-11 11:12 發表
Thanks everyone. I went back to the shop and exchanged a slightly better one. 3300mAh this time. No la, can't afford Trinity la. I am already very happy with my HPI RTR Sprint2. Just wan ...

原帖由 edmundsfc 於 2006-8-12 03:59 發表
This time the 3300mAh battery stopped at 3425mAh... great!!![]()
| 歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://rc-evo.com/xbbs/) | Powered by Discuz! X3.2 |