我想問條軸要幾長???開基米坑係兩邊軸頭度要幾多mm???同埋每個坑位要幾長???(因為手頭上沒有原裝o個條軸來作COPY,希望版友們能提供準確的長度).......
Thanks!!!!!!!!作者: abcde 時間: 2006-10-18 00:18
is the bearing fit , i just try today and find it hard to put in the bearing, then i need remove the blue colour by sand paper ar 作者: xray1980 時間: 2008-1-27 14:15
着么改?,,,,,,,,,作者: epg800 時間: 2008-1-29 00:12
這我有搞過
量好原車軸的長度
將兩端的狗骨鋸掉
比對一下原來的車軸
抓出鎖內六角螺絲的地方
再用銼刀磨出一個平面
這樣就大功告成了!!!
其實用碳纖棒也可以這樣搞
鎖螺絲的地方再點點上瞬間膠
強化碳纖棒的強度就可以了
[ 本帖最後由 xray1980 於 2008-1-29 09:21 編輯 ]作者: epg800 時間: 2008-1-29 17:00
輕很多!!
不過碳纖軸更輕!!作者: chrishkyung 時間: 2008-1-30 15:15
to be honest, its not workable.
Aluminum is not strong enough particular the TT01aluminum shaft. Although its easy for craftmanship, the shaft will be easily bend in running.
Of course, if u change to use grahpite shaft, it will be much better..its sure work
