DSC_4542.JPG (223.54 KB, 下載次數: 135)
2011-5-31 05:38 上傳
DSC_5447.JPG (230.82 KB, 下載次數: 129)
2011-5-31 05:38 上傳
DSC_5449.JPG (275.53 KB, 下載次數: 141)
2011-5-31 05:38 上傳
作者: andyQQ 時間: 2011-5-31 08:16
Good ! Is it DIY drill at original ?
作者: t3lover 時間: 2011-5-31 11:04
Ha... Put AMB at front to gain timing advantage ???
作者: GigaRacer 時間: 2011-5-31 11:43
本帖最後由 GigaRacer 於 2011-5-30 19:55 編輯
回復 andyQQ 的帖子
I believe the 1st and 3rd pic were DIY drill on the plastic piece. 2nd one got an after market center piece that has a center mounting hole on it. Mostly need to glue the servo....
Hopefully the Exotek solution will have a servo mounting position.
作者: punchan 時間: 2011-5-31 18:44
C hing請問第二幅圖油壓是否漏油 ? 新設計好唔好彎 ? 等你的賽後報告 !! 謝謝 !!
作者: carvenchow 時間: 2011-5-31 23:55
xray始終都變番雙星 so sad
作者: GigaRacer 時間: 2011-5-31 23:58
回復 punchan 的帖子
C hing, none of those are my car. I switched club to TCX.
作者: punchan 時間: 2011-6-1 12:49
謝謝！
作者: x-ray 時間: 2011-6-1 18:00
請問軑角調幾多??
| 歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://rc-evo.com/xbbs/) | Powered by Discuz! X3.2 |