RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 用電一問 [打印本頁]

作者: vonerr    時間: 2011-6-16 20:16
標題: 用電一問
想問LiPo電可否用落有刷電變,有刷 11t motor 上???
MAny many thanks!!!!
作者: Allan007    時間: 2011-6-16 20:48
回復 vonerr 的帖子

Why not?
作者: BMW2011    時間: 2011-6-16 21:02
回復 vonerr 的帖子

可以...........
作者: vonerr    時間: 2011-6-16 21:11
thanks c hing, 因有師兄之前提過可能傷電
作者: Allan007    時間: 2011-6-16 21:36
vonerr 發表於 2011-6-16 21:11
thanks c hing, 因有師兄之前提過可能傷電

主要係因為有刷電變通常都冇LiPo-cut。
作者: vonerr    時間: 2011-6-16 21:54
Allan007 發表於 2011-6-16 21:36
主要係因為有刷電變通常都冇LiPo-cut。

but is it has something call lipo cutoff module to  install to prevent such happen?
作者: Allan007    時間: 2011-6-16 22:03
vonerr 發表於 2011-6-16 21:54
but is it has something call lipo cutoff module to  install to prevent such happen?

Yes, you're right.  Novak has such a thing to intercept the throttle signal and stop the motor from running when the battery voltage is below the critical value.
http://www.teamnovak.com/products/lipo_cutoff_module/index.html
But most CHing just install a buzzer which will sound when the battery is below a certain voltage.
作者: pwcp    時間: 2011-7-13 21:03
請問樓上CHING所講的BUZZER裝置是怎樣的? 有現成的賣的嗎?
作者: Allan007    時間: 2011-7-13 21:18
pwcp 發表於 2011-7-13 21:03
請問樓上CHING所講的BUZZER裝置是怎樣的? 有現成的賣的嗎?

這個不是buzzer,而是同你cut油。RCMart有售。
作者: ryancmlam    時間: 2011-7-13 21:59
you can also buy this "low volt throttle cut" device from KWS, ~$75
作者: Allan007    時間: 2011-7-13 22:27
pwcp 發表於 2011-7-13 21:03
請問樓上CHING所講的BUZZER裝置是怎樣的? 有現成的賣的嗎?

Oh!  I mis-understood myself.  Yes, such buzzer is ready made.  It connects to the balance port of the LiPo.  You can find it almost in every shop in KWS.




歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://rc-evo.com/xbbs/) Powered by Discuz! X3.2