RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: There seems to be a problem with the 5mm pivot ball in SP-1 [打印本頁]

作者: rcnuts 時間: 2013-4-7 19:11
標題: There seems to be a problem with the 5mm pivot ball in SP-1
The threads are not deep enough for 3x6mm flat head screws.

作者: rcnuts 時間: 2013-4-7 19:22
Either a 3x4mm flat head screw(dont know if its available?) or Tamiya 51485 5mm pivot ball will work

作者: rcnuts 時間: 2013-4-7 19:46
Tamiya 51485

Cant even complete the first step on the manual

作者: hsiu 時間: 2013-4-8 01:11
those balls is fine, just force the screws into it, not a problem, wont break anything. everyone I know just force the screw in.

作者: joelo 時間: 2013-4-8 11:08

hsiu 發表於 2013-4-8 01:11

登錄/註冊後可看大圖

those balls is fine, just force the screws into it, not a problem, wont break anything. everyone I k ...

Thanks

作者: rcnuts 時間: 2013-4-8 12:00
Is that a design flaw or manufacturing defect?

作者: chestertai 時間: 2013-4-10 09:43
本帖最後由 chestertai 於 2013-4-10 10:17 編輯

This is a self-lock type pivot ball. If you use shorter screw, you have to add thread lock to prevent loose.

作者: rcnuts 時間: 2013-4-10 14:05
Thanks for clearing that up.

作者: apollo13 時間: 2013-4-10 17:39
Mr. Joe 友情聲演 !!!

http://www.youtube.com/watch?v=8g4nNgLG2Vs&feature=youtu.be

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://rc-evo.com/xbbs/)