RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Light Set for Container [打印本頁]

作者: a4b6cheung 時間: 2007-6-11 01:37
標題: Light Set for Container
Hi all brothers,

My two red bulbs (yes, two bulbs!!) of my Light Set for Container were found not functioned at the same time

. The yellow bulbs are no problems and functioning well. I've checked all connections but its still not working. Do you all know what is going on? Is it just the bulbs burnt? Are the bulbs the traditonal light bulb or LED? If it is a traditional light bulb, where can I buy it? If it is a LED, can I just buy a LED for replacement? Need to add resistor?

My electrical support legs cannot be retract (but it can moving down) recently, it have no movement (move up) whenever I use the linkage or use the switch manually, I've also checked all wirings, connections, also bought some electrical switch for test, but I still can't found out what happened?

Any brothers can advise?

Thanks in advance and sorry for so many problems.

Regards,

作者: 老占 時間: 2007-6-11 04:50

原帖由 a4b6cheung 於 2007-6-11 01:37 發表

 登錄/註冊後可看大圖

Hi all brothers,

My two red bulbs (yes, two bulbs!!) of my Light Set for Container were found not functioned at the same time . The yellow bulbs are no problems and functioning well. I've ch ...

Sorry man.... I'm so tried Now....　

May be tomorrow will give u some IDEAS to request your Problem.... Alright?!　

作者: a4b6cheung 時間: 2007-6-13 19:21
haha...I tried to replace one bulb to LED, it's work and the other one back to work as well.

They are originally connected series.

But any brother help me to found out what's woring with my legs...oh no...is my container legs ar??

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://rc-evo.com/xbbs/)