狗骨就有師兄話唔好滯.....作者: chrishkyung 時間: 2007-12-6 16:45
willing to pay for NT1 and high end engines, why not willing to pay for Xray multi one way diff ?
Xray craftmanshft is worth for $4XX la作者: stanley_wwy 時間: 2007-12-6 17:42 標題: 回復 4# 的帖子 yea....i guess...
but does any brother notice that X-ray front oneway being sold looks different from the one shown in X-ray's homepage?
the one shown in the homepage is silvery....but those being sold are like yellowish........
[ 本帖最後由 stanley_wwy 於 2007-12-6 17:44 編輯 ]作者: chrishkyung 時間: 2007-12-6 18:04
yellowish is spring steel which is good material should be stronger than those silver 7075 material作者: stanley_wwy 時間: 2007-12-6 18:06 標題: 回復 6# 的帖子 i mean the one-way tube.....not the outdrives wor.....作者: cat01 時間: 2007-12-7 00:37
Better to buy x-ray one-way drive or you will throw money away on other after market generic ones. The original x-ray dog bone will wear out the generic drive cups on the one-way very quickly. If you use solid shaft setup it will wear even quickly only after 3 liters of fuel the dog bone was fine. Nearly screwed up the engine when the drive cup and the dog-bone lockup.
if you have the generic one-way tube already, just buy better brand drive cups, but it will require you to place some 6mm shims for the alignment.作者: stanley_wwy 時間: 2007-12-7 06:23 標題: 回復 8# 的帖子 thanks thanks....
that's what I concerned about.......those HUDY Spring Steel CVD are super strong.......killing the cups.....作者: goliath 時間: 2007-12-7 16:29
你係話單向筒外面個層coating？．新一批貨至有．舊貨冇呢層coating．層coating有保護防刮花作用．早知佢會出就唔買住啦作者: stanley_wwy 時間: 2007-12-7 18:26 標題: 回復 10# 的帖子 係呀係呀......個筒呀...
