標題: my 1:12 R5 + A123 is ready to 佐敦谷 [打印本頁] 作者: tekin 時間: 2010-8-20 17:30 標題: my 1:12 R5 + A123 is ready to 佐敦谷 my 1:12 R5 + A123 + 7.5R, 第一次用無刷+A123玩1:12, 唔知咩表現???作者: hardmankam 時間: 2010-8-20 18:10
what gear ratio/rollout?
A123 + 7.5R should be super fast.作者: rcmodel 時間: 2010-8-20 18:54
明天我轉用 7.4v 分體 + 7.5r
現在係 3.14 x 45 x 22 / 97 用a123
轉左7.4v 要再轉roll out ma?作者: hardmankam 時間: 2010-8-20 19:01
What was your motor temp when you tried A123 + 7.5R @ 32mm rollout?
If it is already hot, then you should re-gear for sure.
I would suggest to aim at about 28mm rollout to start. (so use 19 pinion)作者: tekin 時間: 2010-8-20 20:50
i use 94/20, but i don't know that is ok or not???
c-hing, what's gear ratio do you suggest??
what gear ratio/rollout?
A123 + 7.5R should be super fast.
hardmankam 發表於 2010-8-20 18:10
作者: hardmankam 時間: 2010-8-20 21:09
i think 94/20 is ok to start.
(rollout is about 30mm)作者: tekin 時間: 2010-8-20 22:03
c-hing, i don't know what's "rollout"??
is this tire size??
i think 94/20 is ok to start.
(rollout is about 30mm)
hardmankam 發表於 2010-8-20 21:09
this means for 1 motor revolution, your car will travel 30.7mm
note:
when you use foam tire, usually refer to rollout
when you use rubber tire, usually refer to FDR作者: tekin 時間: 2010-8-20 22:55
Thks for your information.作者: swswsw 時間: 2010-8-20 23:37
for yr ref.... currently using Lipo 2S, 26/89, 8.5T. Rear 46mm dia.作者: swswsw 時間: 2010-8-20 23:39
motor temp<50deg作者: rcmodel 時間: 2010-8-22 00:17
今日試左 6.6v 7.5r 30/94 好很快
3.7v 7.5t 30/94 小小快
6.6v 7.5r 22/94 好q慢
特別嗚鳴謝hardmankam c hing教路
期待明天再片過作者: tekin 時間: 2010-8-22 13:05
用life-7.5R玩幾多分鐘??
