RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: del [打印本頁]

作者: jackyrc    時間: 2010-4-21 00:00
標題: del
本帖最後由 jackyrc 於 2011-1-8 19:28 編輯

開帖同大家討論下18仔.OFFROAD.希望大家支持下.
作者: rc10    時間: 2010-4-21 00:09
好鐘意,但少人玩,又無地方玩
作者: gimsink    時間: 2010-4-22 09:38
1/18 offroad, cheap china brand waste of money, high quality car expensive, prefer to pay a little more for 1/10....
作者: wingwing    時間: 2010-4-22 17:35
Losi mini-T同Anderson MB4幾好玩...
作者: bigcow    時間: 2010-4-22 19:09
Mb4用540級摩打超快,正!
作者: jackyrc    時間: 2010-4-23 01:39
本帖最後由 jackyrc 於 2010-4-23 02:02 編輯

MB4原裝是380.C兄改了540是無刷嗎..
我還記得3至4年前初玩時的確比其他18仔強壯.不過要改善驅動系統車要用好多$.現在D強化零件偉高好已少見有.要網上訂了.
作者: jackyrc    時間: 2010-4-23 01:48
本帖最後由 jackyrc 於 2010-4-23 02:04 編輯

Losi mini-T..之前在玩過沙地.跳台.公園球場.2WD比較難控制D.由其是起步及轉彎時,但這樣亦是一種樂趣.

作者: wingwing    時間: 2010-4-24 10:29
Mb4用540級摩打超快,正!
bigcow 發表於 2010-4-22 19:09

請教點樣改到540...
作者: wingwing    時間: 2010-4-24 10:31
Losi mini-T..之前在玩過沙地.跳台.公園球場.2WD比較難控制D.由其是起步及轉彎時,但這樣亦是一種樂趣.
jackyrc 發表於 2010-4-23 01:48

Losi本身啲buggy好強、好好玩,大到1/8,細到1/36都係...
作者: bigcow    時間: 2010-4-24 12:36
回復 8# wingwing

我見到youtube有片,件摩打mount自己改,台灣有賣的,唔好改無刷,掃齒掃到傻!
作者: wingwing    時間: 2010-4-24 16:44
回復 10# bigcow
我用緊無刷,超爽,從未掃齒,我見過喺天水圍有車友用3 cell 5000kv直路過4.5R 1/10 touring 頭...
作者: jackyrc    時間: 2010-4-25 01:46
本帖最後由 jackyrc 於 2010-4-25 02:18 編輯

最近好像是流行Tamtech Gear.我今天早上見公園有2父子玩.1人1架.即想起20年前F.1仔時期.
之後去偉高見RTR$11XX.
KIT版得個架無殼.$5XX.(比1/10.更貴).請問KIT版.貴在那裡呢.THX!
有興趣但吾知點買好..(請有玩開的C兄介紹下.謝謝!).THX!
KIT版有無4WD.THX!
作者: wingky    時間: 2010-4-26 09:48
Kit 版有膠油壓, 但冇車殼及電子野, 其他一樣。
4WD 冇 Kit 版。
作者: jackyrc    時間: 2010-5-11 20:06
本帖最後由 jackyrc 於 2010-5-11 22:44 編輯

今天在kws.見出了架4WD.有刷.RTR版.蘇士sc18.聽店舖講會出kit版.

作者: rcf117    時間: 2010-5-11 20:56
kit版好似只有18B2/T2 sc18應該就冇
皮帶18仔玩rally 好左個防沙做得唔錯
作者: jackyrc    時間: 2010-5-11 22:40
回復 15# rcf117

http://www.myrcbox.com/?p=2431
阿葉.紅色星星話遲多少會出kit喎.
(不過d沙.是放不性放.要洗要掃我怕煩.我都會在公園行多)
你點睇架sc18.
定系喜歡16會強壯d.
作者: nel3838    時間: 2010-5-13 22:43
All 1/18 buggy very good fun and save a lot of money.  Dont break easily, parts are cheap.  No need expensive alloy parts in general.   Stick pack and brushless very cheap to setup but very fast too (5200kv, 7200kv crazy fast).  Using motorcycle stick pack is only just 100, 20c 7.4v plenty of punch for a light weight car.

1/18 can do all the style moves just like 1/10 can, and can play anywhere really.

My favorite is still the Kyosho Mini Inferno.  Anderson parts are from taiwan and very expensive.  

I heard from KWS that there might be a new version of Kyosho Mini Inferno this summer, that comes with normal servo, esc and receiver, which are all separate.  Therefore, no more need to waste money with the old (4 wire) kyosho setup.  Hope this is true then can get more parts later.


作者: jackyrc    時間: 2010-5-14 01:07
1/16的Kyosho Mini Inferno的電子部份其實有無都無所謂.如果出kit版是最好的.因為用大改時可以買少D零件,
如果比我會買油動版改,因為套金屬叉及底板確比較強壯.及會先玩油後改380無刷.用返1/10的ESC便可.見KWS有LOSI 380摩打賣.
作者: jackyrc    時間: 2010-5-14 01:13
18仔最貴是車架.如果要大改.D$洗到怕.
而電子野EZ無刷都算平靚正.(可能重平過有刷).
作者: rk2    時間: 2010-5-15 12:57
Losi mini-T同Anderson MB4幾好玩...
wingwing 發表於 2010-4-22 17:35


I have both..... but less time to play ....
作者: rk2    時間: 2010-5-15 12:59
Mb4用540級摩打超快,正!
bigcow 發表於 2010-4-22 19:09


how about use 1/18 brushless   .. ..  
作者: bigcow    時間: 2010-5-15 13:10
回復 21# rk2
都可以試下啊!^_^
作者: nel3838    時間: 2010-5-18 00:03
I have two brushless mini inferno, both run very good laaa....  and cheap to run and lots of fun.
作者: nel3838    時間: 2010-5-18 00:06
waiting to see if there is a new mini inferno with normal electronics, can then change to brushless easily ...

prefer to have sensored 380/370 size motor but unfortunately, other than expensive novak (and currently no stock), all small 370 motor from hobbywing, SP etc are sensorless.  This is not so good for offroad especially for going up slow hill with power, sometimes no response, unless gear down, but then not very fast.
作者: jackyrc    時間: 2010-5-18 01:26
本帖最後由 jackyrc 於 2010-5-18 01:35 編輯

其實我英文好差.如果誤會c兄意思請見諒!(剛剛夠普通幼稚園高班).....
如果18仔用18t.5800kv.370size都夠用啦.但mini inferno 是1/16.車重好多.起碼用380size至會夠力夠快.
我之前試過買540摩打座改有刷玩過但是叉速及其他轉動系統頂吾順.
作者: nel3838    時間: 2010-5-18 15:50
本帖最後由 nel3838 於 2010-5-18 15:52 編輯
其實我英文好差.如果誤會c兄意思請見諒!(剛剛夠普通幼稚園高班).....
如果18仔用18t.5800kv. ...
jackyrc 發表於 2010-5-18 01:26


sorry C-Hing, not good typing chinese.  

Agree with you that 370 slight under power.  I find it is ok with with high KV and with low pinion gear.  I use a 5800kv but use 12T pinion on the Mini Inferno.  It seems high rpm with brushless works better as efficiency is higher at high RPM, and so not much heat.  And the esc is ok too, no overheat.

Here is a link of my mini inferno, I post earlier with the special modification on the servo mount, to allow the mini inferno to use stick pack.  Hope this is useful idea for C-Hing moon.  

http://bbs.rc-evo.com/viewthread.php?tid=173749
作者: 勞力士    時間: 2010-5-21 01:44
本帖最後由 勞力士 於 2010-5-21 01:52 編輯

1/16mini inferno.價格高企.用料勁差.勁吾低玩.原裝車慢到好似慢爬車..過哂氣啦.
作者: 勞力士    時間: 2010-5-21 01:48
1/18.新車當然是SC18啦.$1280(RTR).不過吾知用料如何.




歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://rc-evo.com/xbbs/) Powered by Discuz! X3.2