1:8 GT & 電平8 玩家專區

JUst tried this setting and 2 viper burn off today.....

2nd one...

Hi PYC,

Then Viper is very funny, i went to HUng Sing and Viper's website, they all said must change the pwm to 32000 for high KV motor.

However the setting from stock is completely different. is like a trap. I listen to sop advice change the gear back to 46 and 16T.. not even 1 lap the car stop. so i quickly bring back to my room to check and try turn on again, then smoke came out...WTF?? I spend 16XX on a ESC and if doesnt even run 1 lap? I have used most other brand and try extreme gear ratio like 41/21T with all major motor brand and it works fine, not just fine is perfectly fine.

My friend did the same is if doesn't even run 1 lap and stop middle of the track and the esc start to burn off...IN REAL FIRE!!! Then he change back to an old esc with SAME setting, remember is same setting!! And it runs like there's no tomorrow.

What a disapointment!! Anyway I would highly recommend Viper look in to this and if any ching do want to try, THINK DOUBLE !!!:@:@:@

good luck, me and my friend burn 3 of them already.....

tkwcrash 發表於 2013-7-18 02:54
OMG  6架電

Ching, may I know what brand are they and where can I get them?

thanks, I do want to see other than serpent and motonica, is there any other brand?

thanks ching

tkwcrash 發表於 2013-7-21 03:12
平8試車＋爆菊

http://v.youku.com/v_show/id_XNTg1NTAxOTA4.html

Ching, may I know what brand you guys play?

Thanks.

is Motonica easy to get parts?

whatafather 發表於 2013-8-2 23:26
here it is

Ching, I bought RS 3 as well.

Which esc you using? also motor dont need heatsink??

whatafather 發表於 2013-8-5 00:11
過咗一陣, 再著機, 有番電, 校"立" D 部電變如 throttle punch drag brake 等等，好再出發

o依有轉向, 但 ...

Ching, You may need heat sink for motor...overheat will cause esc blow up..
I blow up 2 viper already, now using toro ( it has turbo), but not tune it too much incase it blow up..
So far esc i think is good is HW and Toro (still need to test out).