本帖最後由 chacha 於 2010-10-23 13:18 編輯
lipo over charge lithium --> lipo over charge lithium
World's Most Dangerous Battery! ---> World's Most Dangerous Battery!
Lipo 電 Spec:
***Storage***
Unlike certain other types of batteries, lithium polymer batteries can be stored for one or two months without significantly losing charge. However, if storing for long periods, manufacturers recommend discharging the battery to 40% of full charge. In addition, other sources recommend refrigerating (but not freezing) the cell
***Charging***
LiPoly batteries must be charged carefully. The basic process is to charge at constant current until each cell reaches 4.2 V; the charger must then gradually reduce the charge current while holding the cell voltage at 4.2 V until the charge current has dropped to a small percentage of the initial charge rate, at which point the battery is considered 100% charged. Some manufacturers specify 2%, others 3%, but other values are also possible. The difference in achieved capacity is minute.
Balance charging simply means that the charger monitors the voltage of each cell in a pack and varies the charge on a per-cell basis so that all cells are brought to the same voltage.
It is important to note that trickle charging is not acceptable for lithium batteries; Li-ion chemistry cannot accept an overcharge without causing damage to the cell, possibly plating out lithium metal and becoming hazardous. Most manufacturers claim a maximum and minimum voltage of 4.23 and 3.0 volts per cell 低過3V每片電就過放,這片電池就要說再見. Taking any cell outside these limits can reduce the cell's capacity and ability to deliver full rated current.
Most dedicated lithium polymer chargers use a charge timer for safety; this cuts the charge after a predefined time (typically 90 minutes). |
[複製鏈接]
收藏
勁正
嬲嬲
樓主
你邊度令到10a出嚟呀
....我想知......你想谷爆舊1萬電快game over嗎？..達人哥哥？
