請問邊道有得車金屬/炭籤底板

請問邊道有得車金屬/炭籤底板 & 大概要幾錢(1:10車)? 沉日炒斷左

What is your model?

You mean that one? Only 1mm thick light weight aluminium deck, mainly for protection, so your classic graphite or plastic deck never need to change.

[ 本帖最後由 raymen 於 2007-6-26 22:10 編輯 ]

原帖由 raymen 於 2007-6-26 22:09 發表

                               
登錄/註冊後可看大圖

What is your model?

You mean that one? Only 1mm thick light weight aluminium deck, mainly for protection, so your classic graphite or plastic deck never need to change.

No. I mean the whole Chassis.

The car swerved at full speed and planted itself on the curb. The fiber chassis basically splitted.

It's a Kyosho ZR-1 (the gas powered corvette back in 1995), so I doubt I can find ready made parts for it.

sure you can make it. Just copy the whole chassis to a aluminium board or fibre board drill all the holes and slots...... I have done this few times since 1980'S

原帖由 rk2 於 2007-6-30 09:36 發表

                               
登錄/註冊後可看大圖

sure you can make it. Just copy the whole chassis to a aluminium board or fibre board drill all the holes and slots...... I have done this few times since 1980'S

Did you cut the boards by hand or by machine?

好原始........, 線鋸   + 銼 -- 修直條邊

原帖由 rk2 於 2007-6-30 11:40 發表

                               
登錄/註冊後可看大圖

好原始........, 線鋸   + 銼 -- 修直條邊

Thanks! 睇黎又要做一輪苦工...