1cell 玩 4Turn 脹電

各位 ching, 玩 1 cell 有無脹電情況呀, 小第用緊 silverback 50c/60c, SP2.1 + TP 4T, 玩左兩次就脹晒... 玩1cell 黎講算唔算正常呢。。。

silverback電有問題脹電。

回復 watsonliu 的帖子

5A

Ching, 我想問用1cell LIPO battery 放電, 應該要用几多 A 來放(discharge)?

回復 billlkyy 的帖子

Ip 咁堅?

我rollout 43...tire 50mm gear 26/94 silverbacks 漲晒不過ip電就冇事等改玩3 cell

hm.... i dont have problem when trim down the speed before... i just thought my laptime is too slow at JV (15.45), so im pushing the limit.. maybe change 2 cell later, thanks chings

回復 levinng 的帖子

I am also using 1S 50C+4T+Turbo(15) without any problem.

But you can try smaller gear ratio 96/18 with 45mm = 26-27mm rollout (in JV)

回復 levinng 的帖子

出廠設定咋！齒比64  96/20  呔43mm

回復 dragonofgreen 的帖子

可唔可以share 下個ESC setting?

Hobbywing 120A +3.5R+ 1S IP 40c 我無事喎！
時間同齒比唔岩！或者你有無磨呔（有Ｄ好大口徑）

levinng 發表於 2011-8-8 13:55

                               
登錄/註冊後可看大圖

回復 hardmankam 的帖子

1cell with 4T is superhot too.. which 2 cell you're using...

Actually I have 2 x 12仔: 1 link and 1 t-bar
1. link car I am using 2xA123 + 10.5 + boost
2. t-bar I am using BY energy softpack, 4500/25c.  (I have to raise the battery 3-4mm to clear the t-bar in the middle)

If you have the link car, most c-hing will use 1/18 2s 1800mah battery to play.

回復 hardmankam 的帖子

1cell with 4T is superhot too.. which 2 cell you're using...

脹電 is a common problem when playing low-turn motor + boost/turbo using 1S.
That's why I play with 2S + 8.5 and the speed is as fast as 1S + 4.0

回復 hardmankam 的帖子

i see... good to try, I set boost 12" only...

回復 levinng 的帖子

I know 64pitch, but the size of the pinion/spur will affect the motor's efficiency slightly.
maybe you can try a larger spur, like a 96 or even 100.
(usually a smaller spur requires the motor to work more, thus using more current on your battery)

Also, are you using turbo/boost function on your sp2.1?

回復 hardmankam 的帖子

64p, 92/21

回復 levinng 的帖子

Your gear ratio is 4.38... but what spur size & pinion (teeth) are you using?

回復 jf813 的帖子

所以先出post請教下, 粒電玩完之後係比起玩 2cell 5.5 turn touring 熱好多.... 睇黎1cell 玩4T唔可以set太盡.... 唉.. 唔盡又唔夠快..... 唯有玩死晒d電轉行2cell試下啦...

4.38 should be ok wor....  50mm rear tire roll out 36mm.  45mm rear tire roll out 32mm....  I use 33mm roll out with 3.5motor no problem wor......  Hum......  don't know.....