MINI Z & KO控

請問各位用KO控既師兄, 特別係EX-10, 有無跟KO網以下既SETTING呢??


http://kopropo.com/america/support/mini-z-help-center/

2.4GHz ASF Settings
Setting up your 2.4GHz Kyosho Mini-Z with any of our supported KO brand transmitters with modules, you will need the following settings.

• Set the steering Travel
  
                                 
  登錄/註冊後可看大圖
  to 70 or 70%.
• Set the steering Balance to NO MORE then 70%.
• Set the throttle High Point to 60.
• Set the throttle Brake to 60.
• DO NOT use the Quick Steering or Quick Throttle Response found in the EX-1 UR transmitter.
  

These settings for your transmitter will help to ensure that you 2.4GHz Mini-Z will operate correctly.

When I first bought my MR03 stock car, I followed the recommended settings.  As I started upgrading parts, I changed the settings accordingly.  The recommended settings are safe settings and good for stock car.  Just be aware of the setting of Steering Travel, setting it too high may make your servo gear set break faster.  Balance can stay at 70%.  High Point and Brake depend on your motor, battery, and circuit board (with added FETs or not).

kevt2005 發表於 2014-3-27 00:09
When I first bought my MR03 stock car, I followed the recommended settings.  As I started upgrading  ...

Well noted your suggestion, I will try the different of steel travaling point at 70%. - 100% accordingly.
Acutally, I play drift with my comic racer only, 70% of ST angle might not enough.